Melbourne Water
Social and Environment Data
2005 / 2006

Back

Routine inorganic chemical parameters

Exceeding reporting level and percentage in zones/population

The reporting levels for iron, aluminium and manganese are based on Australian Drinking Water Guidelines (2004). The level for fluoride is based on the Health (Fluoridation) Act 1973. Target levels are equal to or less than the reporting level or, in the cases of fluoride, within the range shown. The reporting levels for iron, aluminium and manganese have been established on aesthetic grounds rather than health considerations. The range for fluoride is that recommended for the control of dental caries. The guideline/reporting level for aluminium is for acid soluble form. Sampling results are based on monitoring at the locations listed in our agreements with the retail water companies. Fluoride concentrations at the points of introduction into the system comply with the calculated annual and short-term averages required under the Standards for Fluoridation of Public Water Supplies. Values outside the reporting range tend to be low rather than high and zones where fluoride is not added or is incidentally reduced by further treatment influence results.

Parameter / retail water companies Report- ing level Total zones Total tests Total Exceed- ence % Fails No. Exceeding Reporting Level (& %) in Zones/Population
Below 10K 10K to 100K Above 100K
Tests Fails % Fails Tests Fails % Fails Tests Fails % Fails
Iron (mg/L)
ALL 0.3 70 2275 0 0.0 777 0 0.0 1342 0 0.0 664 0 0.0
YVW 0.3 35 1273 0 0.0 374 0 0.0 833 0 0.0 365 0 0.0
CWW 0.3 11 691 0 0.0 - - - 458 0 0.0 278 0 0.0
SEW 0.3 30 999 0 0.0 351 0 0.0 400 0 0.0 414 0 0.0
Aluminium (mg/L)
ALL 0.2 70 664 0 0.0 287 0 0.0 347 0 0.0 169 0 0.0
YVW 0.2 35 516 0 0.0 237 0 0.0 249 0 0.0 121 0 0.0
CWW 0.2 11 243 0 0.0 - - - 122 0 0.0 127 0 0.0
SEW 0.2 30 171 0 0.0 25 0 0.0 66 0 0.0 122 0 0.0
Manganese (mg/L)
ALL 0.1 70 1031 0 0.0 324 0 0.0 613 0 0.0 309 0 0.0
YVW 0.1 35 604 0 0.0 201 0 0.0 379 0 0.0 159 0 0.0
CWW 0.1 11 383 0 0.0 - - - 249 0 0.0 156 0 0.0
SEW 0.1 30 388 0 0.0 110 0 0.0 148 0 0.0 187 0 0.0
Fluoride (mg/L)
ALL 0.7-1.2 70 919 18 2.0 142 5 3.5 761 13 1.7 431 4 0.9
YVW 0.7-1.2 35 591 9 1.5 101 1 1.0 526 8 1.5 261 3 1.1
CWW 0.7-1.2 11 366 0 0.0 - - - 209 0 0.0 187 0 0.0
SEW 0.7-1.2 30 391 10 2.6 52 3 5.8 218 7 3.2 261 3 1.1

Note: Some monitoring locations cover multiple zones, different population groups or more than one retail water company.

Click on the links below for information on Melbourne Water’s: